Techgenix Solution

Product Detail

Emax Simonk Series Multirotor 30a Brushless Esc (Original) is a Brushless Dc Motor Speed Controller. The Low Output Resistance Greatly Enhances Power Stability, and This Will Improve the Great Battery Life. Emax Simonk Series Multirotor 30a Brushless Esc is Programmed to Start the Brushless Dc Motor. This Esc Has a Greater Current Handling Capacity Which is 30a Continuous and the Peak Current is 40a for the Last 10 Seconds Only.
Features :Based on Simonk Firmware, Further Optimized to the Perfect Drive Performance.Low-voltage Protection, Over-heat Protection, and Throttle Signal Loss Protection.Separate Power Supply for Mcu and Bec, Enhancing the Esc’s Ability to Eliminate Magnetic Interference.Parameters of the Esc Can Be Set via a Program Card or Transmitter.Throttle Range Can Be Set to Be Compatible With Different Receivers.Equipped With Built-in Linear Bec or Switch Bec.Max Speed: 210,000 Rpm for 2-pole, 70,000 Rpm for 6-Pole, 35,000 Rpm for 12-Pole.

3 Months WarrantyThis Item is Covered With a Standard Supplier Warranty of 3 Months From the Time of Delivery Against Manufacturing Defects Only. This is a Quality Product & Only Manufacturing Defects Are Covered Under This Warranty. Reimbursement or Replacement Will Be Done Against Manufacturing Defects.
What Voids Warranty:If the Product is Subject to Misuse, Tampering, Static Discharge, Accident, Water or Fire Damage, Use of Chemicals & Soldered or Altered in Any Way.

Product Specification
Product Description

This 5010 360KV High Torque Brushless Motor for Drone comes with self-cooling technology, so they will be able to withstand high temperatures up to 140° C (356 F).
This brushless motor for the Drone is evaluated by the high torque offered by them. The motor gives an awesome flight experience on behalf of the NdFeB magnets and properly lubricated high-quality ball bearings.
They can be paired with 14″ to 16″ Orange series HD Propellers and powered by 2S-6S Orange Li-PO Batteries through 20A-40A ESC.
They are equipped with high-temperature wires in windings of the motor to minimize the burning of the motor. Also, they have high-temperature adhesives which are used to secure the stator windings and prevent them from shifting and getting pinched or shorting out.
Features : 

Equipped with four fan-style cooling holes that pump air through the motor while it runs.

Rear threaded mounting holes with both 16 mm and 19mm hole spacing fits a variety of applications.

NdFeB magnets with the high-temperature rating for trouble-free operation.

140° C high temperature rated wire is used for winding the motors.

Plates are epoxy coated on the inner surface to prevent winding short out.

Lubricated ball bearings are used to support the motor.

High-temperature adhesives are used to secure the stator windings and prevent them from shifting, getting pinched or shorting out.